Alliedassault - View Single Post - REquesting Modeler Help a problem i have ran into!

Dr. Deleto · 07-12-2003, 09:23 PM

I told you this before. Whatever you named the clip mesh, put that in those lines.

for the BAR its something like..

14 surface Clip +nodraw
47 surface Clip -nodraw

the numbers represent the timing aspect of the animation.
"surface Clip" is the animation surfacing the mesh named "Clip"
+nodraw, and -nodraw are the animation removing the implied mesh or replacing it.

in other words. If your clip mesh is named "Skin4" then your animation line should be as follows.

14 surface Skin4 +nodraw
47 surface Skin4 -nodraw

hope you understand this.

	(#4)
Dr. Deleto is Offline Senior Member Posts: 1,469 Join Date: Sep 2002 Location: At the bar	07-12-2003, 09:23 PM I told you this before. Whatever you named the clip mesh, put that in those lines. for the BAR its something like.. 14 surface Clip +nodraw 47 surface Clip -nodraw the numbers represent the timing aspect of the animation. "surface Clip" is the animation surfacing the mesh named "Clip" +nodraw, and -nodraw are the animation removing the implied mesh or replacing it. in other words. If your clip mesh is named "Skin4" then your animation line should be as follows. 14 surface Skin4 +nodraw 47 surface Skin4 -nodraw hope you understand this.