question about prefabs?

keeper · **question about prefabs? -** 08-31-2002, 01:57 AM

can you build a whole building all finished and save it as a prefab?

r3mix · 08-31-2002, 06:47 AM

yes.
whatever bunch-o-shit you can select together you can export to prefab

r3mix

keeper · 08-31-2002, 01:35 PM

thx, but when i load my building map it takes about 5 minutes to move it one inch, any idea's why this happens?

r3mix · 08-31-2002, 10:15 PM

yeah i get that to... it has to do with the system im using.... technically termed a "shitb0x"

r3mix

keeper · 09-01-2002, 08:23 AM

well i got a p4 1.6 gf3 card and it does it real bad????????

-=[XTC]=-Body Bagger · 09-01-2002, 10:21 AM

I have a good sytem, but also have the same trouble moving large prefabs.
What i do is, make a base for the building on the map where its final position is going to be. Then save that as a prefab. Load it back into radiant build the house, re save it as a prefabs then load the finished prefab back in to my map and voila.... its in the right position , no moving required
Craig

RUNGSI · 09-01-2002, 02:34 PM

Yea I do the same thing.
map out the area, transfer over just the area. then build my structure.
then once finished i can transfer it back and everything fits without moving it.
if the area is differant.
I select the prefab.
goto open the map and it will copy.
once map opens. give it a few seconds. let memory catch up. or it will crash on you.
set the prefab as structural. SAVE map
then i will select the prefab and move it from there.. so if it crashes. aleast the prefab has already be transfered.